NexStorm strike plots counted but not showing on map.

There can be two reasons for this behavior.

If strikes plots are shown after restarting NexStorm:
Ignore uncorrelated strikes filter (CTRL+I) is turned on under the TRAC settings tab in the Configuration dialog. The reason that strike plots are shown after a software restart is because this filter will reset and not process archived lightning data which loaded after restarting.

If strike plots are not shown after restarting NexStorm:
Density plot mode (CTRL+A) is enabled. This display mode will never show strike plots and density fields will only become visible once there is significant amount of lightning activity. Switch to strike plot mode to see strikes on your map.